Seats from Citroen ZX - Trevor Borg
	Step 1 Find seats in scappy. Step 2 Hand over cash in return for seats.( in my case the seats were quite good, so cost £30, out of a Citroen ZX Volcano) Step 3 De-robe seats, remove all staple fastenings, springs, lumber support and recliner adjustment knobs. Step 4 Cut 140mm centre of rear of frame, 50mm from centre of top of backrest, and 100mm from centre od front of seat. Step 5 Re-weld seat frame back together and adjust the original spings to fit new smaller frame. Step 6 Cut 'V'shape from foam padding to suit new frame, i.e back support 50mm to 140mm from the centre, seat 140mm to 100mm from centre. Step 7 Glue foam back together and attach to frame. Step 8 Cut and re-stitch seat covers as dimensions above. Step 9 Attach seat covers to frame and foam.(I did this using lengths of copper electrical wire to enable me to get all the support pieces back into thier rightfull places. The headrests are going to be fitted to the rollcage on my car, so I didn't bother to fit them to seats. I am very pleased with the result, they fit the lowcost perfectly. On close inspection, new seam down the centre.